# This is an example resource file for rTorrent. Copy to # ~/.rtorrent.rc and enable/modify the options as needed. Remember to # uncomment the options you wish to enable. scgi_port = 127.0.0.1:5000 enable_trackers = yes session_save = yes encoding_list = UTF-8 # Minumum amount of peers to connect per torrent, if available. min_peers = 1 # Minumum amount of peers to connect per torrent. max_peers = 200 # Same as above but for seeding completed torrents (-1 = same as downloading) min_peers_seed = 1 #max_peers_seed = 50 # Maximum number of simultanious uploads per torrent. max_uploads = 5 # Global download rate in KiB. "0" for unlimited. download_rate = 0 # Global upload rate in KiB. "0" for unlimited. upload_rate = 0 # Default directory to save downloaded files. Note it doesn't support # space yet. directory = /tmp/harddisk/torrent/work # Watch a directory for new torrents, and stop those that have been deleted. schedule = watch_directory,5,5,load_start=/tmp/harddisk/torrent/dl/*.torrent schedule = untied_directory,5,5,stop_untied= # Close torrents when diskspace is low. #schedule = low_diskspace,5,60,close_low_diskspace=100M # Default session directory. Make sure you don't run multiple instance # of rtorrent using the same session directory. Perhaps using a # relative path? session = /tmp/harddisk/torrent/session # The ip address reported to the tracker. #ip = # The ip address the listening socket and outgoing connections is # bound to. #bind = rakshasa # Port range to use for listening. port_range = 51778-51778 # Start opening ports at a random position within the port range. port_random = no # Check hash for finished torrents. Might be usefull until the bug is # fixed that causes lack of diskspace not to be properly reported. check_hash = no # Set whetever the client should try to connect to UDP trackers. use_udp_trackers = yes # Alternative calls to bind and ip that should handle dynamic ip's. #schedule = ip_tick,0,1800,ip=rakshasa #schedule = bind_tick,0,1800,bind=rakshasa # # Do not modify the following parameters unless you know what you're doing. # # Hash read-ahead controls how many MB to request the kernel to read # ahead. If the value is too low the disk may not be fully utilized, # while if too high the kernel might not be able to keep the read # pages in memory thus end up trashing. hash_read_ahead = 5 # Interval between attempts to check the hash, in milliseconds. hash_interval = 10 # Number of attempts to check the hash while using the mincore status, # before forcing. Overworked systems might need lower values to get a # decent hash checking rate. hash_max_tries = 3 # Max number of files to keep open simultaniously. #max_open_files = 128 # Number of sockets to simultaneously keep open. #max_open_sockets = # Example of scheduling commands: Switch between two ip's every 5 # seconds. #schedule = "ip_tick1,5,10,ip=torretta" #schedule = "ip_tick2,10,10,ip=lampedusa" # Remove a scheduled event. #schedule_remove = "ip_tick1" # Stop torrents when reaching upload ratio in percent, # when also reaching total upload in bytes, or when # reaching final upload ratio in percent. # example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0 #schedule = ratio,60,60,"stop_on_ratio=200,200M,2000" schedule = ratio,30,60,stop_on_ratio=200 # Encryption options, set to none (default) or any combination of the following: # allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext # # The example value allows incoming encrypted connections, starts unencrypted # outgoing connections but retries with encryption if they fail, preferring # plaintext to RC4 encryption after the encrypted handshake # encryption = none # Enable DHT support for trackerless torrents or when all trackers are down. # May be set to "disable" (completely disable DHT), "off" (do not start DHT), # "auto" (start and stop DHT as needed), or "on" (start DHT immediately). # The default is "off". For DHT to work, a session directory must be defined. # dht = on # UDP port to use for DHT. # dht_port = 51778 # Enable peer exchange (for torrents not marked private) # peer_exchange = yes safe_sync = yes receive_buffer_size = 4096 send_buffer_size = 4096 # # Do not modify the following parameters unless you know what you're doing. #